Making Wood Furniture
Joints You Might Find On Solid Making Wood Furniture
Solid Making Wood Furniture can be bought in many different places – it is a popular type of furniture. The type of joints used by furniture makers varies and there are a few you should know about. The more you know about how furniture is made, the better equipped you are to choose the best pieces for your home.
History of Traditional Furniture Makers
Traditional Making Wood Furniture makers will use the wood itself to create a joint. High-tech methods are at the opposite end of the scale and they require expensive machinery and glues. Factories lend themselves to the high-tech joints because they can achieve mass production this way. Individual joiners are more likely to use traditional methods that have served the industry well for years and years.
Butt joints are probably the simplest type of joint because they just require two bits of wood to be butted up against each other and then fixed with nails, screws, dowels or glue. This is also the weakest type of joint though so should be avoided for anything that needs to take any significant load.
The simplest joint that requires cutting is the miter. It is really an angled butt joint with the two bits of wood that come together being cut at 45 degrees to create a 90 degree angle. It is fixed with glue.
Dovetail joints are probably the most widely known of any joint. Many cabinet makers use it as the joint of choice. You will recognise it because it resembles the tail of a dove and it is often found where two pieces of wood come together at right angles. The join requires no glue because the joiner must cut two perfectly locking shapes that will hold together and give strength to the Making Wood Furniture.
The mortise and tenon joint dates back thousands of years and is used by woodworkers all around the world. It has a lot of surface area that can be used for glue and can be used almost invisibly if desired. The mortise part of the joint is the square or rectangular hole and the tenon is the wood projection that slots into the hole. Usually it will have shoulders that sit flush to the edges of the mortise when the joint fully enters the mortise hole.
Tongue and groove joints can be found in wood panelling, for example on wardrobe fronts. It is also commonly used on flooring. The two bits of wood are cut so that they slide together. The tongue is the bit of wood that slots into the thin, deep ridge cut to take it (known as the groove).
Now that you know a bit more about how wood is joined together, you will be able to spot the basic different types in the Make Your Own Bedroom Furniture you see in stores.…
